ISP-Adapter for the breadboard

The old workaround
The old workaround

The common programmer-adapters for AVR-controllers come with a ten-pin connector that is connected to the target circuit. Why the thing has to have ten pins, I don't understand. Four of them are connected to the ground, and one isn't connected at all. So effectively there stay six pins that are really solving a purpose.

The problem

The new adapter's front...
The new adapter's front...
... and rear
... and rear

When developing a prototype on a breadboard, it is not really possible to connect the ten-pin connector on it. I built myself some kind of an adapter cable to connect every pin onto the board.

As you can see, it's really ugly and not quite stable. Plastic parts are getting weak during the soldering-process, and they are not really stable.

The solution

The adapter at work
The adapter at work

To make it a bit more elegant, I made this little tool. I printed the pin configuration using Eagle CAD. You can find the required file in the end of this page. So I just have to consider the controller's documentation for the pin-settings, not for connecting the ISP-adapter to it.

Beneath the printed cardboard, there is a simple circuit board. Otherwise there is a ten-pin connector for connecting the ISP-adapter, and a six-pin connector that is attached to the breadboard. I pressed the pins until they are almost fully beneath the board, so it fits tighter to the breadboard.

Oh, and the wires on the board's lower side are painted. And not soldered really niceliy, but the mainthing is: it works!

 

Download

adapter.ps.gz

The printed label

11.2 K